Clean Low Mile, Built Stroker

Description for Buick Grand National 1987

I am the third owner and it is an original low mile Grand National. I have a clean FL title in hand.

Just under five hundred miles on build. Link to Youtube video:https://www.youtube.com/watch?v=jfb7xfOcvRw

Motor:

249 Cubic inch stroker motor

270-Stroker 4340 billet crank (3.625)

Molnar Technologies 5.960 rods

J/W flexplate

Diamond pistons with total seal rings

1.55 scorpion roller rockers

212/212 roller cam

GN1 Aluminum race ported heads

GN1 72mm Throttle Body and power 6 Plenum

GN1 valve covers

Precision CEA BB polished 66mm turbo

HR motor mounts

RJC lightweight pullies

RJC power plate

Champion ported intake

Champion fuel rails

Polished 200 AMP alternator

Exhaust:

RJC 5 inch stainless downpipe

RJC 4 inch full stainless exhaust

RJC 4 inch intake pipe polished

PTE front mount intercooler

TA performance coated headers

Fuel system:

340 Walbro pump with hotwire kit

Eric Marshall 93 chip for alky

83lb injectors (Modded ECM by Bob Bailey)

Progessive Alky Razor dual stage kit

Drivetrain:

Stage 3 extreme automatic 2004R trans with electric brake

Pro 9.5 inch non-lock converter from extreme automatics

Largest BM trans cooler on the market, installed under passenger side battery

Eaton posi unit

Moser 28 spline axle

Moser Aluminum Rear Cover

Moser driveshaft safety loop

Denny's 3.5 Aluminum driveshaft

Suspension:

Ridetech stage II suspension coil overs (fully adjustable) front and back

Upper Tubler Strongarm with tall ball joints

Lower Tubler Strongarm with double sheer lower mount

HR rear adjustable sway bar

BnM upper rear shock mount

GNX rear seat brace welded in

Original wheels with Mickey DRs

Aftermarket CCWs 18x9.5 fronts and 18x10 rears, perfect offset wrapped in nitto tires

MISC:

GNS dash conversion, all custom gauges, speedo works from GPS and logs time, ET, auto recall, etc...

TR6 control module (includes two step and rev limiter)

Caspers relocation harness for module

Polished battery cover

Powerlogger software with tablet

Full LED light kit for parking and rear taillights

Custom 8 point roll cage with full function interior (Cage installed by Martin Brothers from the TV show Iron Resurrection: (Season 2 episode 3 titled Corvette Fulie)

I can provide more details if you have any questions: 813-309-0144