1961 Chevrolet Corvair 95 Rampside Truck
1961 Chevrolet Corvair for sale in Avoca, Wisconsin, United States
Condition: | Used |
Item location: | Avoca, Wisconsin, United States |
Make: | Chevrolet |
Model: | Corvair |
Type: | U/K |
Trim: | 95 |
Year: | 1961 |
Mileage: | 17,440 |
VIN: | 1R124S102132 |
Fuel: | Gasoline |
Transmission: | Manual |
Drive type: | RWD |
Vehicle Title: | Clear |
Want to buy? | Contact seller! |
Description for Chevrolet Corvair 1961
Up For Auction Is A
1961 Corvair Rampside Truck
This is a partially completed project vehicle that I don't have time to finish and I need the storage area before winter arrives.It starts and runs well but needs further attention to be fully road worthy. I bought it last year after an estate auction and have completed quite a few repairs and replacements since then. It is a basic model with the 3-speed manual transmission and no options.
A few of the completed items include:- -replaced choke cable with new original
- -replaced accelerator cable with new original
- -replaced fuel pump with new electric
- -replaced both carbs with fully rebuilt units
- -replaced distributor with later model including new points, ondensor, ap, otor and vacuum advance
- -new coil, park plugs and wires
- -new battery & battery cables
- -disconnected and drained fuel tank (rusty and leaking), emporary tank installed for testing (see photo)
- -new air filters, il and oil filter, arious wiring, prings & fasteners
All parts were purchased from Clarks Corvair Parts.
Items that need to be done:
- -remove old gas tank and install new, ined tank with new sender and all new connections and hardware (all of these parts are included)
- -replace intake valve seals (included)
- -replace pushrod o-rings (included)
- -replace valve cover and oil pan gaskets (included)
- -replace voltage regulator (included)
- -adjust valves
- -adjust and synchronize carbs
- -replace brake master cylinder (new dual system kit included)
- -replace cab carpet and backing (included)
- -service brakes as needed
- -refurbish and adjust shift linkage (new bushing included)
- -install Pertronix ignition system if desired (included)
Again, ll parts were purchased from Clarks.
There are other new and used parts that will be included as well as a complete set of manuals.
The primary mechanical issue with the truck is that while it starts and idles well, t does not have much power
which I think is because it needs the valves adjusted and the carbs adjusted and synced.
The brakes work but would probably benefit from cleaning and adjusting.
There is some body work that was performed by a previous owner that should probably be re-done (see photos).
There is a rubber lip fastened to the sheet metal below the front bumper (photo) that hides some contact with the ground or ?
This would make a great project for someone with the time and mechanical skills. It is very close to being road drivable.
More photos are available here: https://flic.kr/s/aHskh6RJsn
This vehicle is sold as-is, here-is with no warranty of any kind. Actual total mileage is unknown. eBay requires that the mileage is listed in the ad so I have listed the current odometer reading.
The buyer is responsible for transportation however I can assist with loading. It is located in Wisconsin and comes with a clear Wisconsin title.
This vehicle is for sale locally and I reserve the right to end this auction at any time prior to reserve price being met.
Please call me with any questions: Paul 608-532-686zero CST