1990 C4 Corvette Coupe. L98 5.7L Engine, 6 Speed Ton of new parts go with car

Description for Chevrolet Corvette 1990

1990 C4 Corvette Coupe. L98 5.7 Liter Engine, /u>

6 Speed T56 Trans 140k miles

Ton of NEW PARTS go with car see list below

If you want to see the car, essage me.

Bought as a project car but no time to work on it.

I was told that the engine was rebuilt by the previous owner. Upon inspection, he inside of the motor looks clean as if it had be redone recently.

Fuel injection is off the car because I was trying to track down a vacuum leak. Leak was found, bolt was missing on a fuel injection runner.

Correct GM Performance Aluminum Heads, ummit 1.6 Ratio Rockers, T1 Valve Covers and SLP runners. Some mild porting work had been done.

I installed a new stainless fuel pickup assembly and gauge sender, ew AC Delco fuel pump and pickup screen, ew gas cap and new gas fill trim cup. During that process I flushed out and inspected the tank bladder, t is in good condition.

Has the factory 17 x 9.5 rims with good tires.

Body is decent, o major damage, ome small stress cracks. Paint on hood has typical peeling clear coat. Interior needs work but is usable, ew weather stripping set and window sweeps come with car (See below) A set of 95/96 Tan leather buckets were installed by prior owner. Some cracking but very usable. Aftermarket CD Radio has been installed

Exhaust appears to be recently replaced

K&N Air Filter (Used in good shape with cleaner / oiling kit) Factory Air Cleaner Housing Cut for Max Air Flow, xpanded Aluminum Welded in to keep out the big stuff

The following parts are new in boxes for the car:

Fel-Pro Top End Gasket Set

Fel-Pro Valve Cover Gasket Pair

Fel-Pro Head Gaskets Pair (Correct for aluminum heads)

Viton Fuel Injection O-Ring Set

Set of 24lb Matched 4 Hole Injectors

Fuel Injector Wire Pig Tails

Throttle Position Sensor

Throttle Position Wiring Connector Pigtail

Air Temp Sensor

Idle Air Control Valve

Distributor with Taylor Racing Cap & Rotor

Summit Racing H/O Coil

8mm Plug Wires

Set AC Delco Plugs

Polished Aluminum Timing Cover

Air Pump Eliminator Pulley Kit

Throttle Body Air Foil

Smooth Interior Intake Rubber Duct

Prothane Polyurethane Bushings Full Set

Polyurethane Sway Bar Bushings

Front KYB Shocks

Used Bilstien for rear

Ceramic Brake Pads

Front & Rear Drilled & Slotted Rotors

Earls Braided Stainless Brake Lines

Rebuild Kits and Hardware Kits for all Calipers

Master Cylinder with Reservoirs

Clutch Master Cylinder

U-Joints for Main Drive Shaft and Half Shafts

Hub Bearings for All Four Wheels

Stainless Steel Cap Screw Set for Engine Top End

Upper & Lower Radiator Hoses

Silicone Vacuum Hoses

White Face Gauge Overlay Set

Full Body Weather-strip Set

New Outer Window Sweeps

Hood Release Cable

Rear Hatch Strut Lifts

Stainless, olished. Shorty, enter dump headers

Ignition Switch Tilt rebuild kit

Service manual on CD

K&N Oil Filter

Cue Ball Shift Knob

Upper and Lower Ball Joints

Tie Rod Ends

Rack and Pinion Tie Rods with Accordion Boots

Serpentine Belt