1969 Chevrolet Camaro *new metal****NO RESERVE****

Description for Chevrolet Camaro 1969

1969 Camaro with lots of money and parts invested. The only reason I am getting rid of this car is because I need money to finish up our house that we are building so it has to go, unfortunately. Most of the hard work is done and almost ready for paint and reassemble. I already painted the dash gloss black and put carpet, and door panels in it. The rear panels are useable but need to be replaced. The front seats do not go with the car but everything else you see will be included, as well as the extra parts that was removed will go as well. I have all the trim as seen in the pictures as this car was assembled before all the metal was replaced that was rusted. The doors are original and the rust was cut out at the bottom and new metal was weld in. The trunk pan could use some re-welding and the outer wheel housing need work but everything else is done. I have the original wire harness that is actually in pretty decent shape. The rear frame rails are in great shape and will not need anything done to them. I have disc brakes for the rearend but are not installed that will go with the car. The rearend has already been cut down and waiting on whatever ratio you want to add. I was setting the car up to be a pro-touring car. I do have a LS1 and 6 speed transmission that I might sell for the right price that I was planning on putting in the car but would need around 3500 for the combo. You will have the option of a cowl hood, or a flat hood. The Inner fenders have not been put in the car yet but are in good condition. I do have used front and rear bumpers that will go with the car also. I have pretty much everything except an engine and transmission for the car that is included. The glass will need to be replaced but is all there, as is all the regulators that are already in the doors. This car is very very very close and wouldn’t take very long to have a really nice car. I do not have a gas tank for it but I do have a radiator that will go with the car. I have a new master cylinder and brake booster that will go with the car also. The car will come with a bill of sale and t22 form. The firewall has been painted but has runs that will need to be buffed out or just sand it down and paint It underhood black-up you. The cowl has a couple of very small pin holes but is not bad enough to justify putting a new cowl in for. Just repair whats there if you wanted too. Please contact me if you have any further questions at 404-697-2727. If you have less than 10 feedback please contact me before bidding Good luck!!

New AMD(Auto Metal Direct) sheetmetal

New tail panel

new floor pan

trunk pan

both full quarter panels with sail panels

deck filler panel

trunk drop offs,

new driver fender

Smoothed firewall

Mini tub with ford 9” 31 spline axles with disc brakes(not assembled)

4-linked reraend

Detroit speed mini tub housings

I will require a non refundable deposit of $500.00 within 48 hours after auction ends so please come and inspect or ask any questions about the car before bidding. The remaining balance will need to be paid within 5 days as I need the money to finish my house. I do have the car for sale locally also so i do reserve the right to end the auction early.