1969 Chevrolet Camaro COPO clone project car

Description for Chevrolet Camaro 1969

For sale is a1969 Chevrolet Camaro COPO clone project car
This is a completely frame off and media blasted restoration. The car is rust free as all parts that had any rust have been replaced. This includes the passenger floor, trunk floor, front and rear inner fenders and rear quarter panels. The interior has been painted with sound proofing and the exterior painted with GM black.
The engine is a professionally rebuilt rare 427 cubic inch 425 HP. It is a L72 COPO but it is not the engine that originally came with the car.
Block: 3963512 (F 17 8 casting)Cylinder heads: 3919840Intake manifold:3933163Crank:3856223Pistons:3888304Rods:3969804
The original camshaft had mild wear so the engine was rebuilt with a Comp Cams roller cam, springs and rockers. The ignition is a MSD 6AL. The car has Hooker headers, Pypes pipes and Flowmaster mufflers.
The transmission is an Autogear Muncie M22 4 speed Rock Crusher 26/32 spline and therear end is a 12-bolt 4.56 posi-traction. The clutch and pressure plate are Centerforce. The car has front disc brakes.
The seats and door panels are in very good condition. Additional parts include hub caps, body trim, sound dampening mats, head light rings, heater, windshield wiper, new rear brake plates and shoes. All glass except for the front windshield is included and all four window regulators have been media blasted. There are four wheels and tires not shown in the photos that will ship with the car.
There is a $1000.00 non-refundable deposit due through PayPal within 24 hours of auction close. Full payment is due within 7 days of auction close. Only cash, cashiers check or bank wire transfer will be accepted and all funds must fully clear through my bank before the car leaves my possession. The car needs to be loaded on truck as it is non-drivable because it has no drive shaft.