Camaro 1968 big block muscle car

Description for Chevrolet Camaro 1968

Selling my beautiful black 4 speed Camaro. Car has a fresh 454 built by McBetts racing with a 4 bolt block and completely balanced. Engine was run on dyno and is making 580ft torque and 585hp at 5800rpm. 030 over and stroked using eagle crank and rods with je pistons producing a streetable 10.4 -1 compression, edelbrock rpm aluminum heads all redone with manley valves and comp springs and retainers and roller rockers, comp cams roller cam with .600 lift, edelbrock intake with 850cfm holley and holley blue electric fuel pump, complete msd ignition system with rev limiter, hooker full length headers into 3 inch exhaust exiting after rear wheels.
Northern race radiator with dual spal fans keeps car 185-190 degrees. March serpentine belt system and moroso aluminum water pump.Transmission is a close ratio Muncie m21 redone by Banner transmission with a hurst competition plus shifter and Lakewood full scattershield. Clutch was built by falcon clutch using a diaphragm plate and Kevlar disc and steel flywheel. Car has p/s and p/b with disc on front and rear.
Cal trac suspension using split mono leafs and trac bars. Rear is a ford 9 inch with 3.90 gears and a Detroit locker. Front suspension has all new linkage and upper bushings. Frame connectors and rocket racing wheels with 275/60/15 in rear.
Black and white houndstooth interior with center console.
Drivetrain only has approximately 1500miles on it. Body has mostly new sheetmetal and was done approximately 6 years ago.This is not a show car but a beautiful street cruiser that turns heads everywhere I take it. You will not be disappointed!