1967 C10 Stepside 5.3 LS Swap 425HP 4spd

Description for Chevrolet C-10 1967

1967 C10 stepside

This is a brand new build.. 90% of this truck is brand new

Original patina Cleared over

LS Swap 5.3

Full resto-mod

Engine: 5.3 64,000 Miles

BTR cam

ICT Billet intake and 102mm Throttle Body

ICT Billet accessories

Full stainless 1 7/8" long tube headers

Custom tuned on 91 octane on a Dyno at 340hp to the wheels 420hp crank

-8AN custom Crank Case venting system running through a oil catch can

Every engine sensor is brand new OEM

Frame:

Sand blasted and POR'd

Some frame modifications for engine and gas tank fitment

Interior:

All new floors pansand Dynomat

Updated shoulder seatbelts with middle lap belt

Real double barrel shotgun shifter

Heater controls cables and vents all new and work as they should

Steering column wiring and components all new

Headlight switch brand new

Brand new wiper switch and wipers

New Carpet with pad

Custom made cowhide seat All window and door gaskets are new

Doors have all new locks latches and hardware

All interior lights are LED Conversion

Original dash speedo cable replaced and works

Autometer carbon fiber ultralight gauges are Water temp, Oil Pressure, and Fuel level

Transmission:

Original Muncie Top Loader 4spd

Brand new Clutch and flywheel

All brand new custom made clutch arms from original C10 parts fabricated to fit the LS

Brakes:Disk brake conversion front with all new rear drum and hardware.

Brand new Silverado brake master cylinder and all new lines front to back

Emergency brake functioning like new with all new rear cables and hardware

Exhaust:

Stainless long tubes and 3" Stainless Jones Mufflers with turn downs under rear of cab

Crossmember:

Custom fabricated for fitment of any style trans. Frame rail bolted

Suspension:

Drop spindles in the front and block rear

Still running coils

Wheels:

Brand new 20" Black aluminum rebel racing

Tires are 225/35R20

Electrical:Full painless modern truck harness. Every wire on this truck is brand new

Headlights are LED halo and LED lights

Front turn/marker signals are all brand new with LED conversion

Taillights are original OEM with Led bulb and custom red halo brake light inside

PSI custom tailored stand alone LS Harness with future auto transmission wiring

Fuel:

GM OEM tank out of a Firebird that fit in between the rails

Walbro 255 High Pressure in tank fuel pump

EV1 injectors rebuilt and flow matched Currently only running at 75% Duty cycle

-6AN fuel lines and fittings

Drive line:

Two piece drive shaft completely rebuilt and balanced with all new u-joints and carrier bearing

GM 12 bolt rear end with a very strong posi

4:11 rear gears

Misc:

The bed is reclaimed wood

Everything on this truck is brand new other than the glass, body, trans and rear end.

Truck runs very sound and has a very aggressive idle to it.

It goes down the road straight and the ride is pretty darn good for how low it is..

At 425hp and only weighing 3000pounds this truck gets down...

I drive this to work and car shows all around..

Heater components are all new and work great for those cool fall days

Hear it run @

https://youtu.be/Bdc54reEgSo