1978 Chevrolet ( BIG 10 ) Siverado { Long Bed 9'.9"X Length }350cc,4Brrl,3spAuto

Description for Chevrolet Other Pickups 1978

This Truck has a 350cc. nbsp; 4 Barrel Carburetor . nbsp; (350 Turbo)3spd Auto. nbsp; Posit rack Rear-end. nbsp; (Dual Exhaust Glass Pack). nbsp; Aurora RT02 Radial LT235. nbsp; No ComputerThis truck is a Good Strong Truck. it still runs but I decided back a couple of months ago to go ahead and sale it to some that could take better care Of it now and fix it on up right! It does have a few problems 1. is the Fuel Pump loses pressure after it sets over night and you have to pump the pedal a lot at first to get it started in the morning but it will start before the battery goes dead. 2. The Transmission Pan started to lick a little so I got it fixed now it leaks ?? 3. Not sure but to play it safe check the ball joints I have had them changed and not many miles on them but a person said I needed them and I haven't had a second opinion since. 4. The Plastic gear on the shaft of transmission for the speedometer broke and the guy put a different color one on so it goes about 5 miles per hour slower than it reads. 5. One problem I newer got solved is sludge in the oil pan you are going to have to take the pan off I guess. I have been changing the oil every 200 mile and it is still black. 6. It suppose to have air-condition but someone took the compressor 7. Has a Horn switch for the horn the could not get it to work during inspection one time? 8. As you can tell by the pictures it has some rust it is mainly body wise the cab has some inside on the floor on each side all the way over by the wall and then around the bottom of the doors and some on the finder wells and a little in the middle of the bed of the truck where the frame is attached 9. Needs Paint job the person before me just made strokes! Outside of those problems the only things I have done is put rear tires on and it already has I Low geared rear end great for hauling or pulling. I Replaced the Heads and when I did I put the one on with the over size valves for Pulling. I put a new Starter. Alternator. and keep up with tune-ups (Plugs-Wires) but may need a new one now. I put Ball joints and shocks on it and also put New 4 Barrel Carburetor. Radiator & Heater hoses and belts. Brakes and Calipers The Major work was the Transmission I had it Prof Rebuilt and while I was at it a new fly wheel put on. and the Brakes don't have very many miles on them either. I Purchased the Truck 01/18/01 and I am older and I have drove it some but the last couple of years it hasn't been drove much except around the block or to move with and my moving days are over I hope for a while. I was told when I bought the truck it had been a farm truck. Oh yah it did leave me stranded in a intersection once but some nice people push me out real fast. (( Clogged $2 Fuel Filter on the Carburetor)) Lessen well learnt! Outside of that always made it!