1974 Dodge W-200 4WD 3/4-ton Sno-Fiter with original Meyers plow

Description for Dodge Other Pickups 1974

This auction is for a 1974 Dodge W-200 4WD 3/4-ton Sno-Fiter with original Meyers plow. Has 5. 9L 360 V8 with aftermarket Holley 2-barrel carb. with manual choke. Automatic transmission with 4WD option and locking front hubs. Does not have original box. Box is custom built from what I was told. And it has a homemade tailgate. Currently does not have spark. I think it is just ground wire on wiring harness is melted. which is a simple fix. Motor runs good and tranny does not slip. frame is still solidcomes with original Meyers plow from factory with newer chain. wont lift it (think its o rings) might be the pump and i have an extra one that is included in sale. carb rebuilt in july 2014 along with new fuel pump and filter. Just had brakes redone and axle seals replaced. New brake shoes front and rear. new master cylinder and all 4 wheel cylinders. ew brake hardware. Costed $1200. Will include receipt. Just installed new spark plugs. needs power steering gear box. but can still be driven as long as you add power steering fluid. Has after market tail/turn/brake lights. Mounting bracket for passenger side tail light has broken off and needs to be re welded. Back up light is actually a fog light off a car and is operated by a toggle switch on dash. Heat works. Does not have stereo. also have two extra water pumps. 2 distributor caps. extra starter(dont know if it works). extra Holley 2 barrel carb that probably needs a rebuild. just put tires on it that cost about $1000 if you can find them. and comes with 4 extra rims with tires. have cracks but 3 still hold air. All tires are 33x12. 5x16. 5. When I purchased truck it did not have bench seat. it had a driver seat welded to floor with 4-point racing harness. I removed seat and replaced with bench seatfrom an 80s model dodge pickup. Still has racing harness on drivers side. but shoulder straps have been removed. body and frame are a bit rusty. but still solid. Drivers side front fender is dented and I had to cut a little off from behind tire to stop it from rubbing. missing driver side front side marker lens. I drove this truck in 2 parades and have owned it for a year. Wife is sick of looking at it and I just dont have time to work on it anymore. would be a great project for someone. whether you want a plow truck or possibly even a mud truck. Pictures were taken this past summer. Do not have any recent pictures. Only thing different is the rear tail light stated above. Does have stickers on it also that you can leave or remove. Message me with any questions.