Model A Ford 1928, 1929, 1930, 1931 Hot Rod
1930 Ford Model A for sale in Dundalk, Maryland, United States
Condition: | Used |
Item location: | Dundalk, Maryland, United States |
Make: | Ford |
Model: | Model A |
Type: | Coupe |
Trim: | coupe |
Year: | 1930 |
VIN: | A2982307 |
Color: | Green |
Fuel: | Gasoline |
Drive type: | RWD |
Vehicle Title: | Clear |
Want to buy? | Contact seller! |
Description for Ford Model A 1930
Here we have a 1930 Model A Ford Coupe. All the hard work is done. Original 1932 K member with Model A front and rear cross members al tied in with 1932 American stamping rails. Professionally built. Model A Coupe body has a 3 inch chop with all rusted metal being replaced. (see photos)> Stripped and etched primered. Body was found with minimal rust. All patch panels are brookville roadster panels and have all been completely welded in including new fire wall. Zoomie Header kit with flathead flanges. 32 dash and four gauge panel. New 15 inch wide whites on Buick style rimes with new trim ring Minimal body work before paint. Orignal 1932 heavy axle dropped and drilled by Okie Joe with new Kingpins also installed. 1941 rear axle with 378 ratio. Completely rebuilt. Drive shaft and toque tub cut and matched professionally for 3 speed top loader or side shift.1932 heavy front axle droppedand drilledby Oakie Joe. 1940 juice brakes front and rear plumbed and ready to go with all new shoes and cyclinders and lines and master cylinder. I have close to 100 photos of the build so far. Call Bob at 4435645994 with any questions. Car is for sale locally. I reserve the right to end this auction early. On Oct-19-15 at 05:56:00 PDT, eller added the following information:I've added a few photos so the 350 Chevy guys will quit calling with any interest on this true nostalgia built model a. It had a 50 Merc 8BA in it during mock up. Please don't consider buying it if you plan to not put a flathead in it Find another project that better suits your needs
On Oct-19-15 at 06:23:01 PDT, eller added the following information:I am just trying to clarify that the car is mocked up for a flat not a 350 Chevy engine and trans
On Oct-19-15 at 14:47:19 PDT, eller added the following information:I am now getting questions on bodywork. I have posted photos of the car in bare metal and etch primer. Bodywork will need to be done before painting. All the metal replacement work has been done
On Oct-19-15 at 15:08:55 PDT, eller added the following information:I have added photos of the car mocked up with the 50 Merc flathead and three speed trans. I did not post them earlier because I did not want people to be confused. NO MOTOR OR TRANSMISSION WITH THIS CAR