1972 Ford F100/F-250 Camper Special w/ swapped 4.6 V8 & 5-speed manual

1972 Ford F-100 Camper Special for sale in Buffalo, New York, United States

Condition:	Used
Item location:	Buffalo, New York, United States
Make:	Ford
Model:	F-100
Type:	Standard Cab Pickup
Trim:	Camper Special
Year:	1972
Mileage:	138,000
VIN:	F25YCM84154
Engine size:	4.6L V8
Number of cylinders:	8
Fuel:	Gasoline
Transmission:	Manual
Drive type:	2WD
Drive side:	Left-hand drive
Vehicle Title:	Clear
Want to buy?	Contact seller!

Description for Ford F-100 1972

This was a project truck of mine. I've done ALL of the difficult fitting and fabrication. All that's left is replace a few wear-parts (all included) and if you're not into the patina look restore the exterior.
Rundown of what's installed:
- 2004 Crown Victoria IndependentFront Suspension
- 1998 Mustang GT 4.6 liter fuel injected V8 engine
- 1998 Mustang GT T-45 manual transmission (5 speed)
- 1998 Mustang GT ecu, tuned for 91oct and security system delete
- 2004 Crown Victoria Police Interceptor 3.27 ratio trac-lok 8.8 rear end (posi traction)
- Fleet Pride Driveshaft to mate mustang trans to crown vic rear end
- Air assist rear shocks. fill/service valves mounted in rear bumper near plate.
- 2001 F-150 seats, captains chairs on a bench with fold down center armest console
- Grant steering wheel
- hydroboost brake system
- rear swaybar retrofit
- dual pass brand new aluminum radiator
- Crown Victoria electric fan
- new serp belt
- Cold Air Intake
- Custom exhaust, single exit side dump near passenger rear tire. two glasspacks no cats.
- breaker bar as a shift handle, mounted to a B&M short shift tower
- oil filter relocation kit. easiest oil changes you'll ever do.
- Frame has been stripped and chassis coated
- new floors and cab mounts welded in
- poly cab mount bushings
- began converting to 3-point seatbelts....haven't done Passenger side yet
- Mustang wiring harness and some of stock F-250 harness, wired so that original truck ignition switch works.
- Lifetime warranty in-line fuel pump
- all new brake lines, copper-nickel. will never rust.
- all new fuel line, ran in new plastic. will never rust.
- rear diff was flushed and has brand new fluid with friction modifier in it
- Brand new clutch cable
"The Bad"
- needs some weatherstripping replaced. I bought it and it's included
- needs all the MOOG front end parts I bought installed
- needs rear tires changed, have three spare tires to swap the best two for rears on this.
- no e-brake, was planning to eventually put in a line-lock
- needs the hardlines on the steering rack replaced, one leaks and draws air into the system so lock-to-lock on turning makes growling noises (just ordered these via Rockauto, should be here by friday)
- no radio
- wiper squirts don't work. haven't looked into it. it's two wires to a mini pump, so either wire broke or pump failed or fuse blew
- The gas gauge works sometimes.
- The speedo isn't working, but the changable plastic gear on the end is broken. I ordered a new one, haven't put in yet
- driver side mirror glass is busted, I have that mirror removed currently so it can be taken to a glass shop for replacement.
- needs defroster duct tubes replaced. I have them and they're included
- It needs the driver window mechanism swapped. Have good one, included
- have all new trim clips, as well as the pieces missing in pics. included but need install
Basically, I built the truck to haul vintage bikes for my shop, but my trips have gotten to be less local and I need something I can take on the highway for some serious 12+hr drives. It runs, drives, and stops. it needs a lot of the creature comforts addressed and some simple stuff attended to. It was a dream build of mine that I can cross off my bucket list, but I had my fun and I need something less hot-rodded for truck duty.
Truck weighs 3380lbs, makes about 200hp. it's fun and people ask about it all the time.
If you have any additional questions, feel free to call me at 716-472-8670.