1968 Ford Bronco Half Cab, 3 spd manual, 170ci I6

Description for Ford Bronco 1968

1968 Ford Bronco Sport
This is a numbersmatching half cab. This vehicle has spent the majority of its life (since 1970's) in northern Colorado. The engine runs and was recently started after rebuilding a used carburetor, installing new plugs, plug wires, coil, fuel pump, and valve cover.
The Bronco comes with the below listedadditional parts:
New belts and hosesNew PCV valveTwo radiatorsExtra fuel tankTwo extra steering boxesExtra steering columnHeadlights and trimUsed engine and interior wiring harness
This car has been sitting for a few year because the previous owner completed a carb rebuild that ended up catching the engine bay on fire. As a result, it burned up the engine harness (new/used one comes with the car), the carb, throttle cable, etc. Front frame mounts for bumper have been cut off by the previous owner to remove winch and custom bumper that was previously there. Rockers have been replaced but as can be seen in pictures there are a few areas where the rust has taken its toll (floor boards, behinddrivers door strike and inside of rf inner fender support.
Below is the decoded VIN Plate from the glove box:
Model: U140Engine: 170cid, I6Assembly Plant: Michigan TruckBuild Month: AprilTransmission: 3-Speed ManualRear Axle: 4.11 Gear RatioOriginal Color: Med GreenDSO Code: Kansas CityPlease don'thesitate to ask any questions.