Early Ford Bronco PROJECT

Description for Ford Bronco 1971

Where to start.....This has been a project several years in the making but its time to pass it on...The chassis was largely completed and body remounted to frame to begin metal work.

As you can see, the bronco was completely disassembled down to the frame. Frame was sandblasted and POR-15'd. Work performed to date includes:

New Toms Bronco 2.5 inch lift/shocks

Body lift kit

Front Brake Disc Conversion

All around stainless steel brake lines

New Locking Hubs

New Power Steering

New Master Cylinder (not installed yet)

complete engine rebuild

Edelbrock manifold

Steering Stabilizer

Rebuilt Trans

Rebuilt Transfer Case

New Drive shafts

Distributor, water pump, fuel pump

As far as the body is concerned....The body work was begun. Not bad rust at all. Front passenger floor panel replaced. Driver side replacement panel is included but must be installed. Many parts not shown in pics are included....i.e. speedo cluster, all pedals,

NOTE: The engine has not been run since rebuild. Has been kept lubricated and crank spun.

Please ask questions!!! I spent a small fortune getting it to this point and would love to see it finished.