1969 Firebird Convertible OHC 6 Project Car, Professional Rebuilt Motor & Trans

1969 Pontiac Firebird for sale in Elizabethtown, Pennsylvania, United States

Condition:	Used
Item location:	Elizabethtown, Pennsylvania, United States
Make:	Pontiac
Model:	Firebird
Type:	Convertible
Year:	1969
Mileage:	unknown
VIN:	223679u695328
Color:	Blue
Transmission:	Automatic
Drive type:	Rear
Interior color:	Tan
Vehicle Title:	Salvage
Want to buy?	Contact seller!

Description for Pontiac Firebird 1969

I just acquired this car a gentlemen who had this as a project car and lost interest. This car is very rare asbuilt with this powertrain. I have afolder with over $9000 in receipts for just parts and labor already put into it not including the car itself. This car is exceptional complete. I will try to cover any components that I know to be missing. That being said as a project car there are parts that will be needed to complete the build that I may be missing.

Please look at all of the pictures as like said the car is very complete. While some parts may not be easily seen they are probably there. If you have questions please ask. For example the valance lights and all of the firebird emblems are in the box on the left side of the trunk picture and the second piece of the grille is also in the trunk.

What has been done to the car to this point:

The entire engine and transmission areprofessionally rebuilt andimmaculate. They havebeen stored on a cart since that rebuild.

New floor boards welded in the passenger compartment, revious owner was a welder so the work is quality

New cowl panel welded in

Sub frame cleaned and coated with POR15

A-Arms cleaned and coated with POR15, ebuilt with new ball joints and bushings

Transmission cross member cleaned and coated with POR15

Sway bar cleaned and coated with POR15

Drive shaft cleaned and coated with POR15, alanced and new U-joints installed

New heater core installed

New master cylinder installed

There has been a significant amount of body work completed, lthough some needs to be reworked. For example while it is in primer there are areas where the fill from fitting new quarters should be removed and reapplied from sitting so long the minor rust can be seen in the welded joint that is exposed.

Things that can't be seen in the photos:

The lower bracing under the floor boards needs to be cleaned and POR15ed. This common on a convertible as you can only replace the floor boards by leaving this structure in place since there is no roof to hold the unibody in place. So while not yet completed this shows the work was done correctly.

The lower A pillers below the bottom door hinge need replaced, atches not included but common to the Camaro and available

The trunk floor needs replaced, ut all new panels for this including lower braces are included a shown in pictures

The rear leaf springs and hangers should be replaced

The rear axle is intact and has not be touched so it needs to be cleaned and POR15ed, ossibly rebuilt

For the front fender that shows filler, here is a patch panel to remove that filler damaged area.

New components that are included:

All trunk sheet metal needed for replacement
new frame rails
lower valance
dash panel
radiator support
Entire front end rebuild kit including bushings tie rod ends and hardware
Front poly bushing kit
Rear poly bushing kit
Newfront brake drums and shoes
Rear bumper
Front end hardwarekit (bolts)
All new wheels bearings
Rebuiltfront hub and spindle assemblies
Fuel pump
Torque converter
front springs
rebuilt steering box
headlights
lots of new bearings and hardware not marked
The hood while not new is perfect.

Things known to be missing

Some of the interior panels, assenger door panel
no new top kit
no carpets
no steering wheel

If you have questions please ask and I will try my best to answer. This real is a great project but I have two in process.