1970 FJ40 Factory Soft Top - lncludes Bows and Soft Top!

Description for Toyota Land Cruiser 1970

For sale is my 1970 FJ40 Factory Soft Top (FST), including Toyota OEM bows and soft top! NOT PARTING OUT. This was restored down to every nut and bolt, with a couple non-original but much needed upgrades. I spent over 4 years rebuilding this awesome truck, and used only OEM mechanical parts from Onur (Landcruiser Parts and Consulting) and Toyota. What Toyota didn’t have, I purchased from Kurt at Cruiser Outfitters. Most everything that was done is listed below. I had a terrific time building this FJ40, but I now have kids and I want the whole family to enjoy something else with me! • 1970 Frame and body o Mileage unknown, but rebuilt motor, trans, tcase, frame and body have less than 200 miles • 1973 F Engine rebuilt o New head gasket o New water pump (OEM) o New thermostat (OEM) o New sensors o New fuel pump (OEM) o OEM exhaust manifold (planed & hot-bathed) • New Radiator (OEM) o All new hoses (OEM) • New gas tank o New lines (hard and soft) o New sending unit • Rebuilt 3-speed (all OEM parts) • Rebuilt 3-speed transfer case (all OEM parts)(Georg at Valley Hybrids) • Floor shift conversion • Front Disc conversion w/ axle rebuild o Aisin 80 series master cylinder and booster o New rotors (OEM) o New pads (OEM) o New lines o New bearings (axle & trunion - Koyo) o New axle seals (all OEM) • Rear fine spline differential (from FJ62) o New bearings (all Koyo) o New seals (all OEM) • 1978 FJ40 manual box - rebuilt • All new electrical wiring harness with auto-reset circuit breakers o Toyota Electronic ignition (2F large cap distributor, coil, engine side cover) o Work done by electrical engineer/automotive wiring specialist • Autometer gauges • All OEM indicator lights, switches, knobs, emblems! • All new OEM signal lights (front turn, rear stop, rear indicators, rear reflectors) • Shackle reversal with new Old Man Emu 2.5” lift springs, new bushings, new shackles, new grease-able pins • All bolts (throughout truck) relaced using Cad-plated flange bolts • 4x Toyota OEM Rims & new hubcaps • 4x BFG KO 33” x 10.5” • Corbeau Moab Seats – black neoprene (driver & passenger – very comfy) o Custom mounting brackets • OEM Factory Soft Top Bows o All parts included! • Trollhole Factory Soft Top (looks amazing!) • Replaced rear quarter panels (all welding done by highly qualified pros) • Dashman Dash box • Custom paint using industrial grade o Entire tub taken down to bare metal and primed • Al’s Liner used inside tub • Warn 8247 Winch – completely rebuilt (w/ remote) • Custom bumper