1941 Willys Nostalgia Comp PRO BUILD NHRA Certified 8.50
1941 Willys COUPE for sale in Ajax, Ontario, Canada
Condition: | Used |
Item location: | Ajax, Ontario, Canada |
Make: | Willys |
Model: | COUPE |
Type: | Coupe |
Trim: | NOSATALGIA DRAGS |
Year: | 1941 |
Mileage: | 2,937 |
Color: | Gray |
Engine size: | BLOWN BBC |
Number of cylinders: | 8 |
Fuel: | Gasoline |
Transmission: | Automatic |
Drive type: | RWD |
Interior color: | Black |
Vehicle Title: | Clear |
Want to buy? | Contact seller! |
Description for Willys COUPE 1941
Up for auction is a 41 WILLYS * [with orig.1941 title!]*This is now a full glass body on a square tube frame, uilt for the nostalgia drags.Runs NOSTALGIA COMP. It pulls the wheels every pass [And stays straight!]. Also runs straight on the top end. The engine was overbuilt for this application (that's called insurance). It only runs 5 pounds boost and shifted at 6300. It runs low 140s to mid-140s mph in the quarter with mid to upper 9 second times. It's just a fun car to run!
But, f you want faster it's only a few small mod's away.
(I also have many of the components to make it streetable.)
There are only two used components on this car - 1 the transmission before being built
-2 the Vega steering box before being rebuilt
ENGINE
-Recently built by a well known, ocal, ace engine builder.
- Gen.6 502 stroked to 540 cu. in.
-mounted solid on the engine plates.
- WEIND 671 super charger
-PRO TEK cyl. heads, orted and matched, Ced, heavier valve springs and hardened keepers, ead bolts upsized to half inch, ne extra head bolt installed in the weaker area on the BBC.
- solid roller lifters
-COMP CAMS stainless roller rockers
-COMP CAMS custom ground camshaft.
-stud girdles
-IRON EAGLE H beam rods
- IRON EAGLE stroker crank
-VENOLIA Pistons
-SEALED POWER piston rings
-two 800 cfm QUICK FUELS carbs
-MSD ignition
-custom-built fender well headers (Period Correct] with 3 inch exhaust flanges out of the sides of the collectors.
-electric water pump
-aluminum rad
-set up to run on C 12 racing fuel
TRANSMISSION
-Turbo 400 (modified)
-racing clutches
-reverse manual valve body
-trans brake
-4500 stall COAN 10 in. converter (spec. built for this car)
-BIONDO air shifter
-HURST quarter stick, ith line lock
REAR END
-STRANGE Ford 9 inch carrier, earing support & axle housing
-3.90 Richmond gears with a spool
-STRANGE axles (31 spline)
-flat roller axle bearings
-STRANGE driveshaft
- MARK WILLIAMS pinion yoke
-four link, ith wishbone
-anti-roll bar
-coil overs with adjustable shocks
*The complete driveline runs synthetic lubricants*
WHEELS & TIRES
-Weld rod lites-front 15x5-rear 15x12
- tires-front Mickey Thompson - rear -MICKEY THOMPSON 15x13.5x29" slick's
SAFETY
-fresh dated (quick release) five-point harness
-carbon fiber converter &trans. scatter shield
-6 point cage
- N.H.R.A. certified to 8.50
CAR [General]
-safety glass windshield and rear glass
-all moldings, andles, rill, cript and functional taillights are 41 willys
-original headlights have halogen bulbs and turn signals mounted in housing
-4 inch dropped tube axle uses streetable tie rod ends
-side windows are Lexan
EXTRA EQUIPMENT -wristwatch operated cage mounted camera [still in the box]
-INNOVATE data logger [still in the box] with O2 sensors
new unmounted MICKY THOMPSON 15x13.5 slick's [current tires still good]
D R E engine diaper, still in the box]
RECEIPTS & SPEC. SHEETS come with car
This is a straight up deal. PLEASE, O B.S. ARTISTS OR TIME WASTING BENCH RACERS. THANK YOU.
Viewing is available for prospective bidders. Owner will assist winning bidder in arranging shipping. Deposit of $500 [non-refundable] through PayPal within 48 hours of auction end. balance must be paid and cleared through bank prior to pick up. Any questions or additional info needed, eel free to contact Rick at905-550-1613between6 and 10 PM.