1966 Mustang Coupe "T" code 200 CI I6 cyl,3spd - OVER 50 PICS

Description for Ford Mustang 1966

1966 Ford Mustang Vin 6R07T126614
Assembly plant - San Jose, alifornia
Body codes - 07 Hardto, ngine Code - T I6 200 CID 1V ( CID cubic inch displacement , nit # 126614
This is a 1966 mustang Coupe sprint 200 Automatic. Overall interior is 9 out of 10 Seats have been reupholstered using Cj Pony set. Paint is 8 out of 10. Everything works as it should. You can get in and drive this car anywhere and use it as a daily driver. Purchased the car from the original owner making me the second owner all information listed is described to the best of my knowledge please see car in person and test drive if serious about buying.
Engine: *Dash reads 63,798 miles Pics to show engine rebuilt ( cell phone pics of old Polaroids ) . Original motor rebuilt in 1980's, Driven on weekend cruises when weather is nice and summer car shows.
---I have a folder full of receipts from myself and the original owner of purchases and maintenance records . The following is new
Battery
Alternator
Water Pump
Thermostat
Plug, ire, gnition points and condenser
Belt
Fuel Filter
Heater Hoses
Air Filter with new style air cleaner assembly
All battery wiring with new harness clips on engine harness
CJ pony seats .. front seats replaced . rear is still in great original condition
CJ pony floor board, ear quarter panel patch with trunk drop down panel - (Photos to prove actual repairs were done - no funny business here . I have more than 50 photo, efore and after repairs )
I am also throwing in for free. 2 full quarter panels and 1 fender if you would need these in the future or for another mustang project. !!!!!!!!!!!!!!!
Body/Mechanical: *
Wheel Cylinders
Brake Shoes
Transmission filter & flui, djustment nut seal, ip stick tube
Kick down shifter seal and o-ring
Trunk kit
-----
Bad: Exterior trim showing pitting on chrome door handle, ea size rust bubbles beginning to form on lower right hand corner of drivers door ( see pics , ater channel drains on d/s & p/s have formed rust bubbles. ( See Pics , ransmission front seal is beginning to sweat only in long drives will you notice seepage by the bell housing. There is some slight paint chips on headlight extensions of the car but nothing is rotted or in need of repair.
Interior: *
Carpet is new, eats are clean and were redone using CJ pony kit, Front dash beginning to crack- (have a dash mat installed and looks great), blower works in all mode, ll gauges function as should, orking radio no mods made to dash and front kick panel speakers in place.
I have original photos for the engine which was completely rebuilt some years ago but the car only drove for short while after the rebuild and has very low miles on it as you can see by removing the valve cover it looks brand new, t runs great and purrs quite nicely. Engine was degreased and sand blasted to remove all gri, irt and rust scale . Any damaged areas have been repaired and chassis was primed then painted with chassis paint. Engine was repainted using ford blue engine paint recently to dress up.
Please feel free to contact me at any time for anything or to set up a viewing and test drive.
Thank You!!
Kenny 917-432-4400
image sharing
image hosting 10mb limit