1913 FORD MODEL T SPEEDSTER FRONTENAC WARFORD RUCKSTELL LOTS OF BRASS FUN CAR

Description for Ford Model T 1913

1913 FORD MODEL T SPEEDSTER

speedster is a built car completed in 1996 using all old car parts. speedster is titled as a 1926 ford touring has a 1926 chassis and running gear.

many 1913 ford parts were used for the build like the brass radiator all the lights the fenders steering column and rear deck much brass was

used on speedster like the windshield frame and other pieces much of the brass was hand made.

cowl fire wallis made from 3/4 inch cherry boards seat is American la france fire truck gas tank is from a dodge

chassis is 1926 ford with a Z section at the rear and a model A ford dropped axel front end that lowers the speedster worm gear fore and aft steering is used

engine is 1926 ford with a model A crankshaft and rods over bore .030 that gives a stroker engine of about 190 cubic inches. camshaft is a B grind along with improved oiling

in engine engine runs a Frontenac over head valve head 8 valve with a down draft carburetor and header exhaust with 2 inch plpe out the rear of car.

volkswagon converted distributer and water pump warford 3 speed overdrive transmission ruckstell 2 speed rear end converted to ball bearings

with rocky mountain rear wheel brakes 1926 1927 wire wheels with simulated brass knock off hubcaps.

speedster is a 12 volt car with an alternator.

the only reproduction parts on car are the step plates motor meter mirror and the emblems on the hubcaps. no fiber glass used in build

I would be happy to answer any questions you might have. car is located in RISING SUN MD. about 10 miles from I-95 and 2 miles from MD. route 1

call 1 407 957 5032 best to come and look before you buy thank you for your interest