K5 Blazer,454,Orange,Crawler

Description for Chevrolet Blazer 1978

Rebuilt the .30 over 454 with .10-.10 rods and mains. It has a Howards cams in it .533/.533, 21/221, 75/275, 10 overlap advanced 4 degrees. A real good low RPM cam and it pulls hard there.. Heads were freshened up at eagle machine.I also put a racing HEI distributor with a hot coil. I rebuilt the 750 vacuum secondary carb.

All new duel 3" exhaust system from headers back with stainless steel mufflers..

Tranny is a 400 turboFreshened with a standard valve body. Convertor is a stock convertor

The transfer case I bought is a 205 gear to gear,

14 bolt in rear with 488 gears and stock GM lockup Rebuilt

The 10 bolt front diff has all new components. 488 gears non locker. U- joints thru-out are new.

OE front driveshaft

New rear drive shaft.

New lock out hubs.

4 wheel Disc brakes System

New 31 gallon fuel tank

New electric fuel pump

Rides on 37"X12.50"X16.5 Hummer tires. Western ranch wheels 16.5"X9.75"X8 Lug. 4.5" back spacing.

Also has a killer stereo system in it. 10" sub woofers, x9" mids and 4" front speakers. Interior has been completely redone with exception to the rear seat. Have the old red seat.. just needs refinished. Also has a killer stereo system in it. 10" sub woofers, x9" mids and 4" front speakers.

EVERY BODY PANEL Has been replaced--- Basically firewall and windshield area only thing that has not been replaced on body ---NOTE !!! this was not buil to be a show truck --- this was built to go have fun where ever you want...

New above standard paint job --- can give you all paint code

ALL New seats, loor has been roll on rubber coated and dyno matted. New vinyl floor mat thru out. New front retractable seat belts. Interior has been completely redone including rear seat.

Custom made bumpers made of 1/4" plate steel front and rear.

Front bumper has badlands 1, 000 lbs.winch with remote. --

If you have questions contact me 308-380-0384