Triumph Renown 2000 Mk 2 TDC 1952 Rat Rod

Description for Triumph Other 1952

Seller Notes:"The Renown is 95 % complete Missing Gas Tank, Front Windshield, Couple of sections of Chrome trim Steel frame is 98% solid some corrosion on non critical back bumper support on one side.Aluminum body is 95% solid with small sections requiring attention Floor are 95% solid with small section above wheel wells needing replacement.The truck floor is a wood sectio, it may be better to replace with aluminum.Seats all need rebuilding Engine has not been started but turns Uses leaded gas.
Has no ignition key at present this can be bought for less than $10 . I have the key on order.
Back fenders need to be put in original position. 20 degree off at present
I have the sections to complete the the profile to the end of the running boards.which form part of the front fender sectionsVin is correct see pictures.Brass tag " Florida Vin number."
1Rarity There are 200 remaining of the Total Production of all series,
this last model Mk 2 Renowns TDC with extended body, less than 150 remain of Triumph Renown 2800produced from 1951 to 1954 with a TDC prefix as shown on manufacturers plate.
2 Rarity in US not an export model rhd
3 Rarity this is production # 2 the 2nd one off the line, being they where hand build the 2nd one completed .
Covered less than 900 miles a year 64 years old history
1Reason to buy Rarity Rarity and Rarity sure to appreciate in value
2 Easy restoration with very little body work required.
3 Aluminum body will not rust.4 Hand built with wood and aluminum by Triumph factory in Coventry.5 Parts arereadilyavailable for theengine from Triumph Razor Edge Club.
If you want to take a look ring me on the contact number. I can assist with part and recommend restorers who can assist with the project. Part are reasonable TROC bought them all from Triumph so engines, door seals and numerous other part are easy to get hold of
I have a workshop manual in pdf form.Call 239 451 9074
"Never use a screw when a rivet will do. " To restore you need hand rivet gun and a drill.
This car would make a great rat rod or hot rod. It was modified version shipped to US with lowered roofline and two door.